railmonkey
1 post
Dec 18, 2007
1:21 PM
|
I want to make some wall separators about foot long by five or six feet high. Perhaps staggered. How do I finish the ends of the blocks? What holds the outside edges to the panels?
|
Dennis
Guest
Jan 13, 2008
4:20 AM
|
What is the insulation R factor of the blocks ?
|
CHARLIE
SALES
162 posts
Jan 21, 2008
11:18 AM
|
Hi Dennis,
For energy results please go to our link :http://www.acrylicblocks4less.com/page/page/1089051.htm
----------
Thank You!
Charlie Torres
|
CHARLIE
SALES
163 posts
Jan 21, 2008
11:22 AM
|
Hi Railmonkey,
The loose blocks are made into any design you like. As for finish accessories, you will have to find the appropriate hardware for your project. We have an installation guide link if you wish to get some ideas. http://www.acrylicblocks4less.com/page/page/1650920.htm
----------
Thank You!
Charlie Torres
Last Edited on 21-Jan-2008 11:23 AM
|
ratfancy
1 post
Oct 10, 2008
5:34 PM
|
I'd like to make a free standing wall in our mobile home to replace the sliding glass doors to the Florida room. The doors are off track, so we'd like to build an acrylic block wall with normal door size from Home Depot, just a few inches in front of the old sliding door wall, then when complete, tear out the old sliding doors. Anyone done anything like this? Any advice? Cost?
|
CHARLIE
SALES
181 posts
Oct 22, 2008
2:43 PM
|
Hi Florida,
You will need the following for your panel
1 case of blocks 882 cw (36/case)
2 bags of clips 50-hclips
1 White Acrylic Cualk
Total cost $329.59 includes shipping
----------
Thank You!
Charlie Torres
|
jules
Guest
Feb 28, 2009
10:15 AM
|
do you have a flexible track for a curved wall?
|
CHARLIE
SALES
183 posts
Mar 24, 2009
10:16 AM
|
We do not have a flexible track. All the curved walls are made at the factory and delivered pre-assembled via truck for only $25.00 shipping.
----------
Thank You!
Charlie Torres
888-500-2665
|
